Your First Cleaning with your Winbot X
Once you have connected the Safety Pod, it's time to clean a window.
Attach the cleaning pad to the bottom of the Winbot:
Spray some cleaning solution on the pad - make it, but not soaked. (The exact amount of cleaning solution required will take a little trial and error - we suggest you err on the side of too little at first.):
Place the Winbot X on the window and hold it until it feels attached. The light on the Winbot will become a steady blue.
To start the robot cleaning, you can either press the blue AUTO button on the robot, or press the Play/Pause button on the remote control.
The Robot will clean in either a horizontal or vertical motion - it all depends on the dimensions of your window:
For a more thorough cleaning, you can press the Deep Cleaning button, and the robot will clean in both an N and Z pattern:
You can pause your Winbot at any time by either pressing the AUTO button on the robot itself, or pressing the Play/Pause button on the remote control:
When your robot is done cleaning, it will return to the exact spot where it started. To remove the robot, hold down the AUTO button for five seconds. Please have a good grip on the handle, as the Winbot will slowly lose suction, and disengage from the window.
Remove the Safety Pod and you are ready to start on your next window: